Tools you might need next
Calculate worst-case and RSS tolerance stack for linear dimension chains. Free tolerance stack up tool for tolerance, stack, and more.
Convert between Ra and Rz surface roughness parameters. Free surface roughness ra rz tool for surface, roughness, and more.
Evaluate cylindricity from peak and valley radial measurements. Free cylindricity tolerance tool for cylindricity, tolerance, and more.
This tool applies a standard formula from the relevant domain. The computation is deterministic — given the same inputs, the result is always identical. The formula accounts for the primary variables that determine the output.
Flatness grade from diagonal sweep (ASME B89.3.7)The calculation requires: Peak-to-Valley, Plate Size. Each parameter contributes to the final result according to the formula above. Accuracy depends on the precision of your input measurements.
Updated: July 2026
A typical use case demonstrating the calculator with representative values.
→ Calculated result based on the formula and provided inputs
Enter your own values to get a personalized result for your specific situation.
→ Result calculated from your specific input values
Check the expected unit for each input field (shown as suffix). Converting between imperial and metric units before entering values prevents calculation errors.
This calculator uses the formula shown. Real-world results may vary due to factors not captured by the model. Use the result as an estimate and verify with domain-specific standards.
Estimate surface plate flatness grade from measured peak-to-valley. Free surface plate flatness tool for surface, plate, and more. It applies the calculation formula (Flatness grade from diagonal sweep (ASME B89.3.7)). For example: 3 μm on 600 mm plate — A typical use case demonstrating the calculator with representative values.